Alarm / Immobilizer Has Thrown A Wobbly

Q: I could really really do with some help I have a 2001 Fatboy 1450cc carb model. My alarm / immobilizer has thrown a wobbly is there a way of completely removing it from bike, reason I am asking I can not get a spark or plug in a fault finder to get a fault code. There seems to be no signal from ecu to fault finder all the wiring seems to be good all the wiring has been check out and seems fine. The motorbike garage, sorry not a Harley garage, seems to think its the alarm system any help much appreciated like a wiring diagram of how to remove alarm I hope this makes sense to you.
Kind Regards, Gary in the UK

A: We would not suggest going about it as you mentioned. There are other areas to inspect/test before attempting something so drastic. First, see I’d you can pull up any stored diagnostic trouble codes from your speedo head. You may have a failing crank position sensor, cam position sensor, a bad coil, bad TSSM (turn signal security module. Hopefully not a bad ECM. If your security module is bad. You will need to replace it. Do not attempt to eliminate it from your electrical system. The ECM will still need to detect that a correctly functioning security module is present.
Similar Question:
I have a 2011 ultra classic when the temp outside is hot and the bike gets heated up the speedo and cruse will quit. when it cools down a little it works again any hints.

A: Check your speedo head for stored diagnostic trouble codes. A stored code might steer you in the right direction.

Related Video:
Troubleshoot with Harley Error Codes

Share tips, start a discussion or ask one of our experts or other students a question.

Make a comment:
500 characters remaining

6 Responses to “Alarm / Immobilizer Has Thrown A Wobbly”

  1. Mark Paparello

    Where is the turn signal module located on a 2003 ultra classic

  2. Pete

    I've got a 2001 Road King Harley I bought a ea 501 2 Thunderheart ignition everything works out good except it dies addable 4200 RPM the carb has been worked on it runs perfect under that RPM I just can't get it to run right it cuts out like the rev limiter is being hit

  3. james.power28

    I have a problem more than a commit. am I in the right place, don't want to run over any one.

  4. Darrell

    2008 fltr road glide. will no speedo or tach cause a no spark condition

  5. Elwin

    I don't have an answer but I do have a question. How do I submit a question regarding a problem with my bike? I've tried before but evidently it didn't work.

  6. David

    How do you check the speedo head for stored diagnostic trouble codes?