• 2:37

    How To Kickstart a Harley with a Super E Carb

    So you wanna kickstart a Harley! Since purchasing the Flathead power brand, S&S Cycle has had an influx of customers contact their tech support with questions concerning how to kickstart a Harley Davidson. In this video, S&S Cycle’s Wally Cahill and Bruce Tessmer give us a little insight and a demonstration of how to kickstart…

    Watch Now >>
  • 4:32

    Harley Twin Cam Oil Pressure Relief Valve

    Here is a great tech tip that Mike demonstrates for any members that are working in their Twin Cam, cam compartment. It is always a good habit to remove, clean, and inspect the Twin Cam oil pressure relief valve any time a cam plate is removed. Especially, if there had previously been some type of…

    Watch Now >>
  • 5:44

    M8 Harley Oil Pressure Relief Valve

    Here is a great tech tip that Mike demonstrates for any members who are working in their cam compartment. It is always a good habit to remove, clean, and inspect the M8 Harley oil pressure relief valve any time work is being performed within the cam compartment. Especially, if there had previously been some type…

    Watch Now >>
  • 29:03

    Harley Shop Essentials

    Tommy is gearing up for a big tear down and customization of our 2000 XL to a Harley Cafe Racer. In preparation, Tommy reviews Harley shop essentials, tools and materials that will be needed along the way. Safety is of utmost importance in your Harley shop. Eye and face protection, respirators, gloves, and appropriate clothing…

    Watch Now >>
  • 24:19

    Sportster Forward Controls and Covers Removal

    Before we remove the Sportster forward controls, it is always important to block or seal off any openings in the engine, transmission, or primary drive compartments. Even if for only a short period of time. Debris, dust, or moisture can be damaging or even catastrophic depending on the circumstances. Tommy reminds us of this and,…

    Watch Now >>
  • 55:16

    Sportster Front End Installation Part 2

    We are moving right along with our Sportster Cafe Racer build. Before getting back into the front end, Tommy takes the time to install the powder coated regulator cover as well as the stock horn which has been relocated from the left side of the motorcycle to the front of the motorcycle. It was necessary…

    Watch Now >>
  • 10:03

    Mama Tried 2019 – Show, Racing and More

    Ride and Rally with Fix My Hog in snowy Milwaukee for Mama Tried 2019. Pre-event kick off, parties, racing and a great motorcycle invitational show. We’re not sure if there is a motorcycle event in the midwest that holds a candle to what Scott Johnson and Warren Heir Jr. have created in Milwaukee, Wisconsin. With…

    Watch Now >>
  • 3:41

    Take a Ride – French Quarter to Galveston

    Ride and Rally with Fix My Hog dodging the thunderstorms and loving the ride from New Orleans to Galveston. The original route was 374 miles from the French Quarter in New Orleans to Galveston along I-10 for a total of six hours and twenty five minutes. I knew that with weather stops it would take…

    Watch Now >>
  • 7:33

    Donnie Smith Motorcycle Show 2019

    Ride and Rally with Fix My Hog as Nate Beck heads to the 2019 Donnie Smith Motorcycle Show. Throughout the years, the motorcycle industry has seen various trends come and go, however it also spawned three legends who surpass these trends. From the west Arlen Ness, who sadly passed away recently, from the east, Dave…

    Watch Now >>