Unless you have a kick-start, you’ll need a battery to get your Harley started and to keep it functional. Bob shares some tips on Harley battery replacement and upkeep.
Bob teaches you how to adjust the clutch and primary chain on your Harley Softail or Dyna model. Be sure to achieve free play on the clutch cable to verify that you have proper adjustment on the clutch cable pack, and check for the proper specs in your service manual for adjusting the primary chain (if your model has the adjustment window). Bob finishes by mentioning that when you are doing this type of repair, only factory service gaskets should be used.Watch Now >>
Now that you’ve fully serviced your Harley Sportster, you can take the opportunity to check all of the safety features on the bike. Make sure the lights are working properly, the horn makes noise, turn signals are operational, and all grommets are in place. Then you should check the throttle, add oil and fill the tires to the correct level. Once your finished with the service, get out and ride!
*****The service manual states you should follow your negation cable down from battery and remove nut that secures the connector to ground stud on the crankcase boss behind the starter motor assembly. You will need to do the reverse during installation.Watch Now >>
Bob teaches you how to service the spark plugs on your Harley’s engine. Although you can clean and service your old spark plugs, Bob recommends just buying new ones because they are fairly inexpensive. You should purchase gapped, Harley-only spark plugs which usually come with a gap of 38-43,000th of an inch. After applying some anti-seize to the threads of the new plugs, you can thread them into the cylinder by hand and tighten them with a torque wrench and you’ll be good to go.Watch Now >>
Bob demonstrates the proper technique for checking, servicing and replacing Harley brakes on the rear wheel caliper of your Harley Sportster. He shows how to loosen the caliper, remove the brake pads and install a new set. Once they are in place, he pumps the rear brakes to make sure the caliper is making solid contact with the wheel and checks the fluid reservoir. If the fluid level is low, you should either bleed the brakes or replace the fluid. More Maintenance Videos are listed here.Watch Now >>