Bob and Mark put a Fatboy on the table lift today to demonstrate the installation of a Goodridge front brake line, custom Wimmer air cleaner and Headwinds chrome parts (including a 7” headlight with custom bulb). You’ll have to remove the bike seat and fuel tanks and unplug the dashboard components. They then teach you how to install a Barnett performance clutch cable and actuate the transmission.
Next Video: Installing a custom clutch cable on a Harley
Bob and Mark teach you how to properly service important parts on your bike, including draining and replenishing the fluids, adjusting the clutch and the primary chain, inspecting the clutch cable and servicing the kickstand. They pinpoint a few problems to look for when servicing each of the parts, and give you some tips on how to deal with any of these possible problems. They also stress the importance of paying particular attention when removing and re-installing parts.
Watch Now >>
Bob and Mark show you how to remove and replace the Harley front wheel on your Sportster. They teach you the proper way to take off the brake caliper and wheel axle so you can do whatever you need to do to the front tire. Once the wheel is off you can replace the tire, retrue the spokes or check the rotor.
Watch Now >>
Bob demonstrates how to service the front and rear brake calipers on a Sportster. There are a few changes that Harley has made over the years, so you should be sure to pay attention to the differences; they could affect how you service your bike.
Watch Now >>
Bob bleeds for us. Well, he bleeds the front brakes on this custom caliper set up. He notes the two bleeder set up and that we should remove old fluid before replacing with new. Check your manual DOT4 and DOT5 do not mix. They go pro with the use of a Brake Bleeder that pushes…
Watch Now >>