Bob and Mark discuss the FL dual disc braking system on the Touring model and show you how to service and clean the calipers, replace the front brake pads and replace the brake fluid. They stress that you use only your model year’s brake fluid, Dot 5 or Dot 4, depending. If you mix the two, you could cause damage to your bike.
Bob and Mark put an older Sportster up on the lift to show you how to service the front and rear brake calipers. They teach you which parts to remove, clean and replace, and discuss the components of the single piston-style caliper assembly and how they work.Watch Now >>
In this quick demonstration of the Harley Sportster battery removal, you’ll learn how to remove your bike’s seat and side cover so you can check on the condition of your battery and its operating components. It is strongly recommended that you remove the negative cable of the battery first and replace it last when servicing your bike. If you remove the positive cable first, you risk causing a dangerous spark if the battery comes in contact with your bike’s frame. Bob has been dealing with these batteries for years and removes the neg from the battery. If this is your first time, we highly suggest removing neg from ground stud on the crankcase boss(see images)with wobble extension.Watch Now >>
Bob takes you through the step-by-step process for throttle cable service and adjustment, and air cleaner service or replacement. He discusses the different parts in the throttle system, their specific roles and how to clean and take care of them, then teaches you about the elements of the air cleaner.Watch Now >>
Bob teaches you how to service the spark plugs on your Harley’s engine. Although you can clean and service your old spark plugs, Bob recommends just buying new ones because they are fairly inexpensive. You should purchase gapped, Harley-only spark plugs which usually come with a gap of 38-43,000th of an inch. After applying some anti-seize to the threads of the new plugs, you can thread them into the cylinder by hand and tighten them with a torque wrench and you’ll be good to go.Watch Now >>