Expert installation video on Harley lifter blocks. Bob LaRosa walks us step by step during the installation of the new gaskets, lifter blocks and bolts. When done make sure to place a piece of tape over the lifter blocks to avoid contamination.
Bob and Mark demonstrate the best way to remove and replace the rear tire on your Harley Sportster. Then Bob shows you how to service the rear axle and inspect the wheel bearings so you can guarantee a smooth and safe ride. Also, he makes sure to apply anti-seize on the axle.Watch Now >>
Now that you’ve fully serviced your Harley Sportster, you can take the opportunity to check all of the safety features on the bike. Make sure the lights are working properly, the horn makes noise, turn signals are operational, and all grommets are in place. Then you should check the throttle, add oil and fill the tires to the correct level. Once your finished with the service, get out and ride!
*****The service manual states you should follow your negation cable down from battery and remove nut that secures the connector to ground stud on the crankcase boss behind the starter motor assembly. You will need to do the reverse during installation.Watch Now >>
Bob teaches you how to adjust the clutch and primary chain on your Harley Softail or Dyna model. Be sure to achieve free play on the clutch cable to verify that you have proper adjustment on the clutch cable pack, and check for the proper specs in your service manual for adjusting the primary chain (if your model has the adjustment window). Bob finishes by mentioning that when you are doing this type of repair, only factory service gaskets should be used.Watch Now >>
Tech review of the Harley Davidson charging system. Here’s an easy way to make sure your battery is charging. Everyone is at your house and ready to ride. You saddle up and CLICK, your Harley-Davidson does not start. Bob and Mark review an easy way to check your battery and make sure it’s staying charged.…Watch Now >>