This video shows you how to rebuild a Harley master cylinder. Bob LaRosa works on the 9/16 bore front master cylinder. Get started by removing the cover and any residual fluid or debris. Take everything apart and compare the old to the new parts to make sure you have everything that you need.
Bob and Mark demonstrate the process for lubricating your Harley’s steering head bearings and adjusting the fall-away. As always, Bob stresses the importance of adequately prepping all bolts, consulting your user manual to be sure everything is done correctly, covering any painted areas on the bike and, if possible, working with two sets of hands.Watch Now >>
Now that you’ve fully serviced your Harley Sportster, you can take the opportunity to check all of the safety features on the bike. Make sure the lights are working properly, the horn makes noise, turn signals are operational, and all grommets are in place. Then you should check the throttle, add oil and fill the tires to the correct level. Once your finished with the service, get out and ride!
*****The service manual states you should follow your negation cable down from battery and remove nut that secures the connector to ground stud on the crankcase boss behind the starter motor assembly. You will need to do the reverse during installation.Watch Now >>
Bob bleeds for us. Well, he bleeds the front brakes on this custom caliper set up. He notes the two bleeder set up and that we should remove old fluid before replacing with new. Check your manual DOT4 and DOT5 do not mix. They go pro with the use of a Brake Bleeder that pushes…Watch Now >>
Tech review of the Harley Davidson charging system. Here’s an easy way to make sure your battery is charging. Everyone is at your house and ready to ride. You saddle up and CLICK, your Harley-Davidson does not start. Bob and Mark review an easy way to check your battery and make sure it’s staying charged.…Watch Now >>