• 5:25

    How To Drain Milwaukee 8 Fluids: 4 Easy Steps Mike has the Milwaukee 8 secured to the lift and is ready to begin the service. It is always a good idea to begin with the motorcycle “warmed up”. This way, the oils will more quickly and thoroughly drain from their corresponding compartments on the motorcycle.

    Read more »

    Watch Now >>
  • 1:53

    Simple but often overlooked. Check operation of electrical equipment and switches before you start to service your Harley Milwaukee Eight. Mike Roen walks you through these easy steps as required by your manual’s checklist. We know it sounds simple and it is. The reason you want to do this before service and every ride is

    Read more »

    Watch Now >>
  • 1:46

    Mike’s back to the checklist and check front Harley tire pressure and inspect tread is our next move. Determining whether or not you tires are within spec and setting correct tire air pressure are probably the most vital pre-ride safety checks that need to be completed. Although modern motorcycle tires are manufactured to very high

    Read more »

    Watch Now >>
  • 18:24

    Flushing and bleeding DOT 4 fluid for the Harley hydraulic clutch system is a procedure that is often overlooked. The fluid eventually breaks down over time and after hours of repeated use. How the system works is relatively simple. When the Harley hydraulic clutch lever is pulled, the master cylinder assembly creates pressure in the

    Read more »

    Watch Now >>
  • 2:27

    Spoke tension and condition can often be overlooked on a motorcycle. At the 1k, 5k, 20k service, and beyond it is of utmost importance that the wheels be lifted or removed from the motorcycle for this service. If you are replacing tires at, or near, one of these service points, it would be a good

    Read more »

    Watch Now >>
  • Twin Cam 96 / 6 Speed Tech Updates
    8:46

    Bob walks us through many of the upgrades that we see on the Twin Cam 96 and 103. Brembo calipers, ABS, cableless throttle and a new frame are just a few upgrades from the Twin Cam 88. He also shows us where to grab power for our electronic accessories. Next Video: Harley-Davidson® Oil Change Service

    Read more »

    Watch Now >>
  • Upgrade the air cleaner on your Harley-Davidson
    13:49

    Bob reviews the throttle by wire on the Twin Cam 96 and 103 and how to install an aftermarket air cleaner. He even points out the factory warning on the throttle body box. Next Video: Harley-Davidson® clutch adjustment and service Related Twin Cam 96 video: Front Brembo Caliper and Pads

    Watch Now >>
  • Harley Fairing Bracket Removal For Replacement
    23:28

    Harley fairing brackets can snap and cause a shake or wobble to your inner and outer fairing. Our experts show you how to remove the brackets without tearing the whole wiring harness part. We remove the outer faring. With the use of some common sense and the factory service manual, we remove the brackets without

    Read more »

    Watch Now >>
  • Harley Davidson Fairing Bracket Replacement
    29:40

    Harley Davidson fairing brackets can snap and cause a shake or wobble to your inner and outer fairing. Our experts show you how to replace the brackets without tearing the whole wiring harness part. We replace the brackets with the use of some common sense and the factory service manual. We replace the brackets and

    Read more »

    Watch Now >>