• 012706f_y0d15u_c-race-removal
    17:41

    This video gives us a look at removing and replacing upper and lower neck bearing races on a Twin Cam Softail frame. Some early model Harleys will have a press in neck cup that fits into the neck of the frame. This neck cup holds the bearing race rather than the frame. The process of… Read more »

    Watch Now >>
  • Harley Oil
    8:50

    Time to get this oil tank out of our way so we can continue moving towards removing the engine and transmission on this Twin Cam. Oil Lines Loosen and remove all related hardware and brackets. With the oil tank loose, you can begin pulling the oil lines from the engine crankcase. Do so, by simply… Read more »

    Watch Now >>
  • Harley Primary Drive
    30:24

    Let’s pull the Harley primary drive on this Twin Cam. We have filmed drive removal and installation on a number of models. This time we are working on a 2002 Softail. We are removing the drive so that we can remove the transmission and motor as we make our way to stripping this m/c down… Read more »

    Watch Now >>
  • Stripping Motorcycle
    13:24

    We are getting closer to having the Twin Cam Softail stripped down to it’s bare frame. As Bob moves forward, there are a few important stripping motorcycle tips that remain constant: Take pictures – A couple of seconds it will take you to snap a quick photo may save you hours of aggravation upon reassembly…. Read more »

    Watch Now >>
  • Harley Engine Mount
    13:38

    On the left side, we are just about ready to begin unbolting the transmission and motor from the Twin Cam Softail. All of the wiring harness has already been disconnected. We have removed the throttle cables from the carburetor and the clutch cable from the clutch perch. The clutch cable will be removed entirely along… Read more »

    Watch Now >>
  • Harley Davidson Mount
    6:06

    In this video, Bob and Mark are minutes away from removing the transmission, and later, the motor on the Softail. Let’s look at right side engine mount removal. More Room As many Hoggers already know; you can also be preparing to remove, only, the motor at this point. It is possible to remove the motor… Read more »

    Watch Now >>
  • Harley Davidson Transmission Removal
    14:32

    Bob and Mark are really close to having this Twin Cam Softail stripped down to it’s bare frame. Once the Harley Davidson transmission and engine are removed, they will be down to only a rolling chassis. Starter Removal First, we need to get the starter out of the way before Harley Davidson transmission removal can… Read more »

    Watch Now >>
  • Twin Cam Engine
    4:43

    Bob and Mark are ready to pull this Twin Cam motor and head to the bench. There are many steps and a great deal of labor to get to this point. Here’s a broad overview of areas addressed (broken down, or removed) in order to remove the Twin Cam engine from the Softail frame. Double… Read more »

    Watch Now >>
  • Harley Rear Fender Removal
    9:21

    There are a number of reasons you may need to remove your rear fender. You may not necessarily be stripping your entire motorcycle down to the bare frame as Bob and Mark are doing here. Why? Whether you are doing paint correction/repair, or something custom, it is always better when you can remove a component… Read more »

    Watch Now >>