• Custom Exhaust Install
    13:19

    Bob and Mark prep the FL for a custom exhaust install. New gaskets, flanges and hardware prepped with Loctite allow them to put the new exhaust in place. They work together to get mounting bolts in place and install flange nuts. They install the exhaust shields and claps make sure not to scar the new chrome. Make sure you wipe the exhaust down. Any fingerprints left over can leave a mark on the pipes when they get hot.

    Watch Now >>
  • Supertrapp Custom Exhaust System Installation
    25:37

    Bob and Mark show us an all-in-one kit for performance slip-on exhaust, mapping and air intake. The remove the stock mufflers and install the new slip-on exhaust with a new torca clap. They move up to remove the stock air cleaner and backing plate. They unplug the throttle position sensor and the intake air temperature sensor and install FI control harness. They wire in the FI control harness into the ECM harness. Their next move is to the install the custom air intake, re-install the fuel tank and dash. They calibrate the FI control before the motorcycle is started.

    Watch Now >>
  • Custom 2 into1 Performance Exhaust Install
    9:59

    With the new gasket already installed in the front and rear cylinders on your Softail model, Bob and Mark demonstrate the process for installing a 2:1 performance exhaust. They stress the importance of working with care so that you don’t scratch the surface of the pipe.

    Watch Now >>