• Installation of a Cobra fi2000 PowrPro tuner
    37:18

    Installation of a Cobra fi2000 PowrPro tuner

    You put on that awesome looking high flow air cleaner and free flowing exhaust and now you need to tune your air / fuel mixture. Why not do it 80 x a second with CVT? What is CVT you may ask? Continuously Variable Tuning every time you open the throttle optimizes the acceleration air /…

    Watch Now >>
  • GoPro Harley-Davidson Burnout Video - Sportster
    1:48

    Harley Burnout Video with a GoPro Camera

    We put a GoPro camera on the stock Sportster and then the upgraded Sportster to see what we would capture. The best part about the video is the expression on Bob’s face after we install the upgrades. Burnouts = Happy Next Video: Clutch Removal

    Watch Now >>
  • Troubleshoot Your Motorcycle's EFI system
    14:42

    Troubleshoot Your Motorcycle’s EFI system

    Bob has an FL ready to install a Power Commander. Watch as he snakes the harness through the battery tray compartment and through the frame to the ECM connector on this model. He re-installs the loose backing plates and installs the Power Commander to the ECM with a little dielectric grease. He takes his time to make sure all components are back in their place. The factory did not smash things together so neither should we. He uses tie wraps to keep everything in place. The Power Commander is easily mapped with a computer for the exhaust / air intake set-up on the motorcycle and makes it easy to remap till it’s properly dialed in.

    Watch Now >>
  • Custom EFI Mapping Installation
    13:34

    Custom EFI Mapping Installation

    Bob and Mark install a Power Commander to custom map this Harley after a custom exhaust and air intake. They remove the battery and remove the battery box to properly install the Power Commander. Take your time and only cut the tie wraps that you have to. They have to level the relay box to install this PC since this model has a custom rear fender, check your model and install instructions. Battery back in and they use a little dielectric grease to install the PC plug into the ECM and back to the factory harness. Once the PC is in place they download a map to it for the custom set up from the computer.

    Watch Now >>