• Harley Clutch Adjustment and Battery Connection
    12:27

    Harley Clutch Adjustment and Battery Connection

    New clutch cable and final Harley clutch adjustment to make sure all is operating correctly. Bob connects the battery and gets ready for a test ride.

    Watch Now >>
  • Harley Davidson Fairing Bracket Replacement
    29:40

    Harley-Davidson® Fairing Bracket Replacement

    Harley Davidson fairing brackets can snap and cause a shake or wobble to your inner and outer fairing. Our experts show you how to replace the brackets without tearing the whole wiring harness part. We replace the brackets with the use of some common sense and the factory service manual. We replace the brackets and…

    Watch Now >>
  • Clutch Cable Installation
    10:18

    Clutch Cable Installation

    You’ll need to remove the transmission end cover in order to install the clutch cable during this service on your Touring model. Bob and Mark show you how to install, clean and torque all of the necessary parts when attaching the clutch cable.

    Watch Now >>
  • Clutch Cable Installation / Exhaust Removal
    28:00

    Clutch Cable Installation / Exhaust Removal

    Bob has the motorcycle safe and covered on the lift. He’ll remove the derby cover to start the clutch cable install. He’ll use a cross pattern and takes care to mark the orientation of the cover. With the clutch pack loosened they’ll remove the cable from the lever and perch. Since they will be doing…

    Watch Now >>
  • Clutch Cable Completion of Installation
    9:07

    Clutch Cable Completion of Installation

    Bob installs the clutch cable into the lever and into the perch. He removes any stickers and refills the transmission with fluid. He installs the dipstick and checks fluid level. He finishes the clutch cable install by adjusting the clutch and making sure all clips are in place.

    Watch Now >>
  • Installing a custom clutch cable on a Harley
    7:38

    Installing a custom clutch cable on a Harley

    Bob and Mark demonstrate the proper technique for installing a Barnett clutch cable on a Harley Softail model. Bob discusses some of the precautions you should take when putting the cable in and adjusting it, including how to fasten and torque the holding bolts. They then show you how to re-install the slip-on exhaust. This video will help you navigate the tricky intricacies of manipulating the clutch cable on a Harley.

    Watch Now >>
  • High Performance Clutch Install & Custom Primary Cover
    30:11

    High Performance Clutch Install & Custom Primary Cover

    Bob gives us a nice review the performance clutch set up and the differences over the years. From show and tell to show and install, Bob takes apart the stock clutch springs, plates, fibers, steels and basket. He presses out the old clutch hub and presses the new clutch hub in. We are dealing with springs have safety glasses handy. He walks us through a detailed and complete re-install on the bench and then into the motorcycles. Watch how to replace the clutch and re-install the primary cover for a Harley-Davidson Dyna.

    Watch Now >>
  • Installing custom clutch and throttle cable on a Harley
    15:50

    Installing custom clutch and throttle cable on a Harley

    Bob and Mark show you how to replace a damaged clutch cable and install Barnett throttle cables. They stress the importance of using the new components that come with new Barnett clutch cables rather than the original, removed components. Before you re-install the cables, inspect the slinger mechanism and clutch throwout bearing and several other parts of the transmission to see if they need replacing.

    Watch Now >>