• Custom Headlight & Passing Lamp Removal & Install
    19:24

    Bob and Mark remove a stock Harley-Davidson headlight and passing lamp set-up to install a custom set. Bob notes this is the time to switch out the headlight bulb if need be and keep all your stock wiring intact, don’t just cut it out. From there we go to the bench to wire the custom passing lamps set-up. Mark helps strip, cut, solder and shrink wrap the new wire connections. They install the new setup making sure all connectors work and that the hardware is tight. Nacelle installed and all parts cleaned they show us how the new set-up looks and operates.

    Watch Now >>
  • Custom Headlight & Passing Lamp Removal & Install
    3:44

    In order to install the Headwinds custom 7-inch headlight and bulb and the Headwinds complete passing light assembly onto the stock Fatboy front fork, Bob and Mark start by removing the trim strip on both sides of the headlight cover. They then teach you the full process for removing both the headlight and passing lamps from your Softail model.

    Watch Now >>
  • Custom Headlight / Passing Lamps and Gauge Install
    11:39

    Bob and Mark demonstrate the installation process for the custom Headwinds and Dakota Digital products that you have wired and prepped for your Softail model. These are your headlights, passing lamps and dashboard gauges. This is your last chance to make sure all wires are properly wrapped, attached and secured! Your bike should look drastically different from what you had before your custom servicing. Now get out and take a test drive!

    Watch Now >>