You’ll need to remove the transmission end cover in order to install the clutch cable during this service on your Touring model. Bob and Mark show you how to install, clean and torque all of the necessary parts when attaching the clutch cable.
In this quick demonstration of the Harley Sportster battery removal, you’ll learn how to remove your bike’s seat and side cover so you can check on the condition of your battery and its operating components. It is strongly recommended that you remove the negative cable of the battery first and replace it last when servicing your bike. If you remove the positive cable first, you risk causing a dangerous spark if the battery comes in contact with your bike’s frame. Bob has been dealing with these batteries for years and removes the neg from the battery. If this is your first time, we highly suggest removing neg from ground stud on the crankcase boss(see images)with wobble extension.Watch Now >>
Bob takes you through the step-by-step process for throttle cable service and adjustment, and air cleaner service or replacement. He discusses the different parts in the throttle system, their specific roles and how to clean and take care of them, then teaches you about the elements of the air cleaner.Watch Now >>
Bob and Mark demonstrate the best way to empty Harley fork oil from your Sportster’s front fork sliders and replace it with new oil. It can be a two-man job, so try to complete the service with a friend. Newer bikes mostly use 39-millimeter forks, but most bikes are preset with varying levels of spring in the sliders, so consult your manual before you begin this service. Like any other service, you should clean all of the parts that you remove with parts cleaner to ensure that your bike operates smoothly between services.Watch Now >>
Bob teaches you how to service the spark plugs on your Harley’s engine. Although you can clean and service your old spark plugs, Bob recommends just buying new ones because they are fairly inexpensive. You should purchase gapped, Harley-only spark plugs which usually come with a gap of 38-43,000th of an inch. After applying some anti-seize to the threads of the new plugs, you can thread them into the cylinder by hand and tighten them with a torque wrench and you’ll be good to go.Watch Now >>