Bob demonstrates the step-by-step process for servicing the front caliper and brake pads on a pre-1999 Harley Davidson Softail or Dyna. He shows you how to remove, clean and replace all of the individual parts in the brake system.
In this quick demonstration of the Harley Sportster battery removal, you’ll learn how to remove your bike’s seat and side cover so you can check on the condition of your battery and its operating components. It is strongly recommended that you remove the negative cable of the battery first and replace it last when servicing your bike. If you remove the positive cable first, you risk causing a dangerous spark if the battery comes in contact with your bike’s frame. Bob has been dealing with these batteries for years and removes the neg from the battery. If this is your first time, we highly suggest removing neg from ground stud on the crankcase boss(see images)with wobble extension.Watch Now >>
Bob and Mark show you how to remove and replace the Harley front wheel on your Sportster. They teach you the proper way to take off the brake caliper and wheel axle so you can do whatever you need to do to the front tire. Once the wheel is off you can replace the tire, retrue the spokes or check the rotor.Watch Now >>
Follow along as Bob teaches you how to drain the fluids on your Harley Softail, including the primary, engine oil and the transmission drain plugs. You’ll also learn how to expertly reinstall the oil filter, and which parts must be replaced each time you service your motorcycle. Find your model here and do maintenance on your Harley.Watch Now >>
Now that you’ve fully serviced your Harley Sportster, you can take the opportunity to check all of the safety features on the bike. Make sure the lights are working properly, the horn makes noise, turn signals are operational, and all grommets are in place. Then you should check the throttle, add oil and fill the tires to the correct level. Once your finished with the service, get out and ride!
*****The service manual states you should follow your negation cable down from battery and remove nut that secures the connector to ground stud on the crankcase boss behind the starter motor assembly. You will need to do the reverse during installation.Watch Now >>