Bob reviews how to install a starter on a motorcycle and some of the safety issues we need to be concerned about.
Related on Topic Videos:
Removing Harley Starter and Speed Sensor Location
Harley Davidson Transmission Removal
Chrome Inner Primary Removal Procedure – Removing Pinon Gear / Jackshaft to Remove Starter
Harley Starter Clutch Replacement
Harley 5 Speed Transmission Project
Motorcycle Electrical Wiring and Circuits
Bob and Mark teach you how to properly service important parts on your bike, including draining and replenishing the fluids, adjusting the clutch and the primary chain, inspecting the clutch cable and servicing the kickstand. They pinpoint a few problems to look for when servicing each of the parts, and give you some tips on how to deal with any of these possible problems. They also stress the importance of paying particular attention when removing and re-installing parts.
Watch Now >>
Bob teaches you how to service the spark plugs on your Harley’s engine. Although you can clean and service your old spark plugs, Bob recommends just buying new ones because they are fairly inexpensive. You should purchase gapped, Harley-only spark plugs which usually come with a gap of 38-43,000th of an inch. After applying some anti-seize to the threads of the new plugs, you can thread them into the cylinder by hand and tighten them with a torque wrench and you’ll be good to go.
Watch Now >>
Bob demonstrates how to service the front and rear brake calipers on a Sportster. There are a few changes that Harley has made over the years, so you should be sure to pay attention to the differences; they could affect how you service your bike.
Watch Now >>
Bob walks us through Harley rear wheel alignment. He’ll just loosen the rear axle nut and with a homemade tool he’ll measure the proper distance and adjust accordingly. Next Video: Rear Shock Adjustment and Drive Belt Service
Watch Now >>