Sometimes when we finish a service or install on our Harley-Davidson we want to jump on and go. Bob points out some major motorcycle safety tips before you head out for that test ride.
You Might Also Enjoy...
-
6:37Bob demonstrates the proper technique for checking, servicing and replacing Harley brakes on the rear wheel caliper of your Harley Sportster. He shows how to loosen the caliper, remove the brake pads and install a new set. Once they are in place, he pumps the rear brakes to make sure the caliper is making solid contact with the wheel and checks the fluid reservoir. If the fluid level is low, you should either bleed the brakes or replace the fluid. More Maintenance Videos are listed here.
Watch Now >> -
3:01Tech review of the Harley Davidson charging system. Here’s an easy way to make sure your battery is charging. Everyone is at your house and ready to ride. You saddle up and CLICK, your Harley-Davidson does not start. Bob and Mark review an easy way to check your battery and make sure it’s staying charged.…
Watch Now >> -
24:50Bob and Mark teach you how to properly service important parts on your bike, including draining and replenishing the fluids, adjusting the clutch and the primary chain, inspecting the clutch cable and servicing the kickstand. They pinpoint a few problems to look for when servicing each of the parts, and give you some tips on how to deal with any of these possible problems. They also stress the importance of paying particular attention when removing and re-installing parts.
Watch Now >> -
9:32Now that you’ve fully serviced your Harley Sportster, you can take the opportunity to check all of the safety features on the bike. Make sure the lights are working properly, the horn makes noise, turn signals are operational, and all grommets are in place. Then you should check the throttle, add oil and fill the tires to the correct level. Once your finished with the service, get out and ride!
*****The service manual states you should follow your negation cable down from battery and remove nut that secures the connector to ground stud on the crankcase boss behind the starter motor assembly. You will need to do the reverse during installation.
Watch Now >>
