Fuel and Spark are very important for your Harley-Davidson to run. Here’s a quick look at HD spark plugs.
Next Video: Harley Fork Oil Change Softail / Dyna
Related Video:
Removing and Replacing Harley Fork Oil Dyna
Discussion
One Response to “HD Spark Plugs Service and Replacement”
You Might Also Enjoy...
-
15:58Sportster Brake Pads 1999 & Older Single Piston Calipers
Bob and Mark put an older Sportster up on the lift to show you how to service the front and rear brake calipers. They teach you which parts to remove, clean and replace, and discuss the components of the single piston-style caliper assembly and how they work.
Watch Now >> -
6:37Harley Brakes – Sportster Rear Pad Replacement
Bob demonstrates the proper technique for checking, servicing and replacing Harley brakes on the rear wheel caliper of your Harley Sportster. He shows how to loosen the caliper, remove the brake pads and install a new set. Once they are in place, he pumps the rear brakes to make sure the caliper is making solid contact with the wheel and checks the fluid reservoir. If the fluid level is low, you should either bleed the brakes or replace the fluid. More Maintenance Videos are listed here.
Watch Now >> -
7:28Harley Front Wheel Removal & Replacement
Bob and Mark show you how to remove and replace the Harley front wheel on your Sportster. They teach you the proper way to take off the brake caliper and wheel axle so you can do whatever you need to do to the front tire. Once the wheel is off you can replace the tire, retrue the spokes or check the rotor.
Watch Now >> -
9:32Motorcycle safety inspection after service
Now that you’ve fully serviced your Harley Sportster, you can take the opportunity to check all of the safety features on the bike. Make sure the lights are working properly, the horn makes noise, turn signals are operational, and all grommets are in place. Then you should check the throttle, add oil and fill the tires to the correct level. Once your finished with the service, get out and ride!
*****The service manual states you should follow your negation cable down from battery and remove nut that secures the connector to ground stud on the crankcase boss behind the starter motor assembly. You will need to do the reverse during installation.
Watch Now >>
2003 Harley dyna lowrider 88 inch 100th anniversary , spark plugs keep fouling out after 15 minutes of running , i have tighten intake ,exhaust ,adjust carb a hair . carberator works great no problems just fouls plugs out black and fast