Internal wiring for ape hangers can be tricky. Identify your left and right-hand side controls and the wire location in the plugs. Write down the wire color and locations in case you get called away from the project. We can now reach into the center of the connection and unlock it and remove each wire one at a time. Bob and Mark will also remove the throttle by wire harness.
When you’re adjusting the primary chain on your Sportster model, it’s always specified to adjust it in the tightest spot of its travel. Whether you use the hot or the cold measurement, Harley specifies that you do it in the tightest area. Bob teaches you a quick and simple method for locating the tightest spot in the path of the chain. He stresses that any time you are servicing inside the primary you should always unhook the negative cable.Watch Now >>
In this quick demonstration of the Harley Sportster battery removal, you’ll learn how to remove your bike’s seat and side cover so you can check on the condition of your battery and its operating components. It is strongly recommended that you remove the negative cable of the battery first and replace it last when servicing your bike. If you remove the positive cable first, you risk causing a dangerous spark if the battery comes in contact with your bike’s frame. Bob has been dealing with these batteries for years and removes the neg from the battery. If this is your first time, we highly suggest removing neg from ground stud on the crankcase boss(see images)with wobble extension.Watch Now >>
Now that you’ve fully serviced your Harley Sportster, you can take the opportunity to check all of the safety features on the bike. Make sure the lights are working properly, the horn makes noise, turn signals are operational, and all grommets are in place. Then you should check the throttle, add oil and fill the tires to the correct level. Once your finished with the service, get out and ride!
*****The service manual states you should follow your negation cable down from battery and remove nut that secures the connector to ground stud on the crankcase boss behind the starter motor assembly. You will need to do the reverse during installation.Watch Now >>
Harley tools are not only specialty tools like JIMS and Kent Moore but many that you have in your garage already. Bob LaRosa gives us a great overview on some of the basic tools we need to service our Harley-Davidson from oil-change to custom part install. Bob shows us that tools are only part of…Watch Now >>