New clutch cable and final Harley clutch adjustment to make sure all is operating correctly. Bob connects the battery and gets ready for a test ride.
You Might Also Enjoy...
-
29:51Harley Fall Away Adjustment & Steering Head Bearings Lube
Bob and Mark demonstrate the process for lubricating your Harley’s steering head bearings and adjusting the fall-away. As always, Bob stresses the importance of adequately prepping all bolts, consulting your user manual to be sure everything is done correctly, covering any painted areas on the bike and, if possible, working with two sets of hands.
Watch Now >> -
6:37Harley Brakes – Sportster Rear Pad Replacement
Bob demonstrates the proper technique for checking, servicing and replacing Harley brakes on the rear wheel caliper of your Harley Sportster. He shows how to loosen the caliper, remove the brake pads and install a new set. Once they are in place, he pumps the rear brakes to make sure the caliper is making solid contact with the wheel and checks the fluid reservoir. If the fluid level is low, you should either bleed the brakes or replace the fluid. More Maintenance Videos are listed here.
Watch Now >> -
5:28Draining Sportster Gas Tank & Filter Service
In order to service the fuel filter on your Sportster, you’ll need to drain the fuel tank. Bob demonstrates the best way to do this using a MityVac and a gasoline can. Once you follow his instructions and drain the fuel tank filter, cleaning any dirty parts and tightening any loose bolts, you can refill the tank with fuel and your bike should be good to go.
Watch Now >> -
8:43Harley Clutch Adjustment on a Softail or Dyna
Bob teaches you how to adjust the clutch and primary chain on your Harley Softail or Dyna model. Be sure to achieve free play on the clutch cable to verify that you have proper adjustment on the clutch cable pack, and check for the proper specs in your service manual for adjusting the primary chain (if your model has the adjustment window). Bob finishes by mentioning that when you are doing this type of repair, only factory service gaskets should be used.
Watch Now >>
