A shinny cable will not correct an existing problem so make sure everything is operational when you install the new braided throttle cables. Sometimes you might want to remove the tank to get a clear view of the way the cables route. Take your time and do it right.
In order to service the fuel filter on your Sportster, you’ll need to drain the fuel tank. Bob demonstrates the best way to do this using a MityVac and a gasoline can. Once you follow his instructions and drain the fuel tank filter, cleaning any dirty parts and tightening any loose bolts, you can refill the tank with fuel and your bike should be good to go.Watch Now >>
Bob and Mark demonstrate the process for lubricating your Harley’s steering head bearings and adjusting the fall-away. As always, Bob stresses the importance of adequately prepping all bolts, consulting your user manual to be sure everything is done correctly, covering any painted areas on the bike and, if possible, working with two sets of hands.Watch Now >>
Bob and Mark demonstrate the best way to remove and replace the rear tire on your Harley Sportster. Then Bob shows you how to service the rear axle and inspect the wheel bearings so you can guarantee a smooth and safe ride. Also, he makes sure to apply anti-seize on the axle.Watch Now >>
Bob bleeds for us. Well, he bleeds the front brakes on this custom caliper set up. He notes the two bleeder set up and that we should remove old fluid before replacing with new. Check your manual DOT4 and DOT5 do not mix. They go pro with the use of a Brake Bleeder that pushes…Watch Now >>