With most spring and early summer rallies being cancelled due to a worldwide pandemic, we were lucky Danny and Aga, founders of Bad Grease Clothing were able to reschedule The Greasiest Motorcycle Show for August. This was the third year The Greasiest has gone down in Lombard, Illinois at Brauer House, and even though the event was moved from inside the ballroom to be outside in the parking lot, it remained in the spirit of all things Harley, all things custom.
Read our Ride Blog Here
Discussion
No Comments
You Might Also Enjoy...
-
13:06How To Bleed Motorcycle Brakes after Brake Pad Service
Bob bleeds for us. Well, he bleeds the front brakes on this custom caliper set up. He notes the two bleeder set up and that we should remove old fluid before replacing with new. Check your manual DOT4 and DOT5 do not mix. They go pro with the use of a Brake Bleeder that pushes…
Watch Now >> -
6:37Harley Brakes – Sportster Rear Pad Replacement
Bob demonstrates the proper technique for checking, servicing and replacing Harley brakes on the rear wheel caliper of your Harley Sportster. He shows how to loosen the caliper, remove the brake pads and install a new set. Once they are in place, he pumps the rear brakes to make sure the caliper is making solid contact with the wheel and checks the fluid reservoir. If the fluid level is low, you should either bleed the brakes or replace the fluid. More Maintenance Videos are listed here.
Watch Now >> -
17:14Throttle Cable Lubrication & Adjustment / Air Filter Replacement / Enrichener Cable Service
Bob takes you through the step-by-step process for throttle cable service and adjustment, and air cleaner service or replacement. He discusses the different parts in the throttle system, their specific roles and how to clean and take care of them, then teaches you about the elements of the air cleaner.
Watch Now >> -
7:37Sportster Primary Chain Adjustment & Chain Tight Spot
When you’re adjusting the primary chain on your Sportster model, it’s always specified to adjust it in the tightest spot of its travel. Whether you use the hot or the cold measurement, Harley specifies that you do it in the tightest area. Bob teaches you a quick and simple method for locating the tightest spot in the path of the chain. He stresses that any time you are servicing inside the primary you should always unhook the negative cable.
Watch Now >>
