Using a Phoenix injector to draw fluid from the master cylinder, Bob and Mark show you how to bleed the brake fluid from a Fatboy model. They then demonstrate the easy process for installing a Goodridge performance black brake line and the injection of brake fluid into the master cylinder.
You Might Also Enjoy...
-
15:58Sportster Brake Pads 1999 & Older Single Piston Calipers
Bob and Mark put an older Sportster up on the lift to show you how to service the front and rear brake calipers. They teach you which parts to remove, clean and replace, and discuss the components of the single piston-style caliper assembly and how they work.
Watch Now >> -
7:37Sportster Primary Chain Adjustment & Chain Tight Spot
When you’re adjusting the primary chain on your Sportster model, it’s always specified to adjust it in the tightest spot of its travel. Whether you use the hot or the cold measurement, Harley specifies that you do it in the tightest area. Bob teaches you a quick and simple method for locating the tightest spot in the path of the chain. He stresses that any time you are servicing inside the primary you should always unhook the negative cable.
Watch Now >> -
4:14Harley Sportster Spark Plugs Replacement
Bob teaches you how to service the spark plugs on your Harley’s engine. Although you can clean and service your old spark plugs, Bob recommends just buying new ones because they are fairly inexpensive. You should purchase gapped, Harley-only spark plugs which usually come with a gap of 38-43,000th of an inch. After applying some anti-seize to the threads of the new plugs, you can thread them into the cylinder by hand and tighten them with a torque wrench and you’ll be good to go.
Watch Now >> -
5:11Harley Sportster Battery Removal & Seat Removal
In this quick demonstration of the Harley Sportster battery removal, you’ll learn how to remove your bike’s seat and side cover so you can check on the condition of your battery and its operating components. It is strongly recommended that you remove the negative cable of the battery first and replace it last when servicing your bike. If you remove the positive cable first, you risk causing a dangerous spark if the battery comes in contact with your bike’s frame. Bob has been dealing with these batteries for years and removes the neg from the battery. If this is your first time, we highly suggest removing neg from ground stud on the crankcase boss(see images)with wobble extension.
Watch Now >>
