Bob demonstrates the proper technique for draining fuel from the fuel tank on your early TC 88 Touring model. He also teaches you how to maintain the fuel valve and clean the fuel tank filter once you’ve drained and refilled the tank.
-
7:46
Harley Sportster Rear Tire Removal & Replacement
Bob and Mark demonstrate the best way to remove and replace the rear tire on your Harley Sportster. Then Bob shows you how to service the rear axle and inspect the wheel bearings so you can guarantee a smooth and safe ride. Also, he makes sure to apply anti-seize on the axle.
Watch Now >> -
6:37
Harley Brakes – Sportster Rear Pad Replacement
Bob demonstrates the proper technique for checking, servicing and replacing Harley brakes on the rear wheel caliper of your Harley Sportster. He shows how to loosen the caliper, remove the brake pads and install a new set. Once they are in place, he pumps the rear brakes to make sure the caliper is making solid contact with the wheel and checks the fluid reservoir. If the fluid level is low, you should either bleed the brakes or replace the fluid. More Maintenance Videos are listed here.
Watch Now >> -
8:13
Harley Fork Oil Service
Bob and Mark demonstrate the best way to empty Harley fork oil from your Sportster’s front fork sliders and replace it with new oil. It can be a two-man job, so try to complete the service with a friend. Newer bikes mostly use 39-millimeter forks, but most bikes are preset with varying levels of spring in the sliders, so consult your manual before you begin this service. Like any other service, you should clean all of the parts that you remove with parts cleaner to ensure that your bike operates smoothly between services.
Watch Now >> -
9:32
Motorcycle safety inspection after service
Now that you’ve fully serviced your Harley Sportster, you can take the opportunity to check all of the safety features on the bike. Make sure the lights are working properly, the horn makes noise, turn signals are operational, and all grommets are in place. Then you should check the throttle, add oil and fill the tires to the correct level. Once your finished with the service, get out and ride!
*****The service manual states you should follow your negation cable down from battery and remove nut that secures the connector to ground stud on the crankcase boss behind the starter motor assembly. You will need to do the reverse during installation.
Watch Now >>